On 07/08/2017 05:07 PM, Ausaf Rashid wrote:
I made a new net VM(named my new net VM) based on Debian 9 followed the
website and changed the configuration settings by putting that mac.conf
file in the location ( did this by opening Gedit from my net VM:"new net
VM" as root, writing the given codes and saving it at the given
location, this was the right method right? That is , to save that config
file from the " new net VM" vm)?
Then I changed the net VM of sys- firewall(that was the only one using
Sys-net VM, the default NetVM) to "my new net VM". Again is it the right
thing to do?
But now the problem is that I can't see any interface to connect to WiFi
( wireless network) although I am able to connect to Ethernet.
Note that I am able to use the old NetVM and the WiFi interface and WiFi
works properly. Also that when I checked it I found out that my "new net
VM" doesn't have Linux firmware installed.
If this helps.
Thank you a lot.
(Posting back to qubes-users.)
It sounds like you almost got it: The conf file is saved in the
template, not the netVM. After you do that, shutdown both the template
and the netVM, then re-start the netVM.
--
Chris Laprise, [email protected]
https://twitter.com/ttaskett
PGP: BEE2 20C5 356E 764A 73EB 4AB3 1DC4 D106 F07F 1886
--
You received this message because you are subscribed to the Google Groups
"qubes-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/qubes-users/f8b967d0-981b-2f6f-c16f-8a3fda001601%40openmailbox.org.
For more options, visit https://groups.google.com/d/optout.
