Chris Richmond wrote: > I'm trying to set up ntp on a new Core2 Duo box running Fredora Core9. > It appears that it's local clock runs several seconds an hour fast. I'm > basing this on running ntpdate against the existing box I have running > ntp with pps. It reports skewing the clock by seconds even after just > a few minutes. > > Also, ntpq data shows the jitter as always 0.997, and the offset goes > nuts right away. The poll and reach look like they are working, but > the time just gets away really fast. > > I have another box with the same O/S install and ntp config, and it locks > up right away just fine, so I suspect it's a hardware issue, not a > config problem. > > I've tried to read through the offical docs on the NTP web site on > diagnosing problems, but can't make sense of what some of the > instructions mean. What's missing are examples of what actually > needs to happen. > > In any case, if the actual box's clock is that far off, is it a lost > cause as a time keeper? > > Can I make ntptime correct the kernel's clock enough to get this > to work? If so, how, and can this be done in the bootup scripts? > > Thx, Chris >
What does your drift file say? If the drift is greater than 500 PPM, the clock is sufficiently bad that ntpd can't discipline it. Depending on what O/S you are running, you MAY be able to correct this or maybe not. A typical drift value is less than 50 PPM. _______________________________________________ questions mailing list [email protected] https://lists.ntp.org/mailman/listinfo/questions
