Hello,
I have an issue with the Meinberg software:
I have defined a simple configuration file
Server time1
Server time2
I can see be running the ntpq -p command that the client is using the
two
servers: one as preferred (*) the other one on standby (+) and also the
offset which is around 120 seconds. The problem is that Meinberg is not
setting up the system clock by itself. However, if I restart the
service,
it does it at the start, but if I modify the clock afterwards to
simulate
an offset, it still does not sync system clock.
Thank you!
Radu,
You have had plenty of advice from others about your configuration. Even
without GPS references, NTP from the Meinberg installation should work
correctly under Vista and Windows-7, and likely server 2008 (not tested
here). There are some hints and tips here:
http://www.satsignal.eu/ntp/index.html
including advice about using the Garmin GPS 18/18x LVC and Sure
Electronics GPS evaluation board to make your own stratum-1 reference. I
am on the top floor of a house and find the pickup from modern devices
indoors is adequate.
Cheers,
David
_______________________________________________
questions mailing list
[email protected]
http://lists.ntp.org/listinfo/questions
