Hello Jordan, Happy to know that it works fine now. When you mention C268 below, would you really mean C328 ?? A mica cap is mandatory for C327, I guess, what was fitted there before you replaced it ???
73, Jacques, VE2JFE in Montreal Hi again group, Ok..I'm now able to adjust T207 to produce -7.6 Vdc at E209, so the effort has been rewarded. I wish I could say for certain what the cause for the prior low output has been, but I did not find a faulty component including coil resistances, a bad cable or connector, or anything else. Even C227, the .047uF PIO cap tested fine after I replaced it with a film cap. I replaced C268 and C327 with Mica caps, an 82K resistor and thoroughly checked wiring and switches. The one thing I did find was that C275 had been replaced with a .0033uF cap rather than the .033 called for. I'm not exactly sure what effect that might have had, but there was a reason for the published corrections. I'm going to do some contact cleaning and a little lubrication before I re-intall the deck and move closer to the finish... 73...Jordan VE6ZT ______________________________________________________________ R-390 mailing list Home: http://mailman.qth.net/mailman/listinfo/r-390 Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
