Hi again group...
I've removed the Ant Trim assembly and I'm looking into removing the roll
pin, however I can't find the pin diameter. It also appears from the
different generations of service docs that some were made with set screws
rathern than roll pins.
From the service docs, the RF deck several #6/0 taper pins (.077 in avg.
dia.) which appear to be about the same size or perhaps slightly larger.
Does anyone know the Ant Trim roll pin diameter so I can find the correct
size punch...?
73...Jordan VE6ZT
______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
