Thanks, Buddy. I always want the solution to be simple but that seldom is the case. I had the same user use my computer but they had the same problem.
From: [email protected] On Behalf Of Buddy Walker Sent: Friday, September 11, 2020 6:25 AM To: [email protected] Subject: RE: [RBASE-L] - Debug command while in application Jim You may want to check before adding parts to the TO location to make sure it doesn’t already exist. As to the cause it almost seems like a USER maybe exiting R:Base without letting the code to complete or it could be a certain work station is losing connection. Buddy From: 'Jim Belisle' via RBASE-L <[email protected]<mailto:[email protected]>> Sent: Thursday, September 10, 2020 8:17 PM To: [email protected]<mailto:[email protected]> Subject: [RBASE-L] - Debug command while in application I use the TRACE command quite regularly while in the explorer mode to test my EEPs, etc. I have not used the DEBUG command within an application while an application is being used. We have a form that was working fine for years until about five months ago. Now it inconsistently does not perform properly. It is a simple part movement form that is most of the time a two part system of a FROM and TO. The user is taking parts FROM a specific location and then putting the parts TO a location. The code populates what I call the raw movements table but also updates a part location table. Here is the problem. Every once in a while the FROM or TO part movement will duplicate (I end up with two entries in the raw movement table). PLUS the code that updates the part location table does not fire so no update takes place. There seems to be no consistent circumstances I can point to that causes this to happen. No errors come up when this anomaly happens. Any blues clues as to if a DEBUG is what I should use in the application to figure this out? James Belisle Making Information Systems People Friendly Since 1990 [cid:[email protected]] -- For group guidelines, visit http://www.rbase.com/support/usersgroup_guidelines.php --- You received this message because you are subscribed to the Google Groups "RBASE-L" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]<mailto:[email protected]>. To view this discussion on the web visit https://groups.google.com/d/msgid/rbase-l/CY4PR0201MB3394923B6E454E5FD40A8A7BA0240%40CY4PR0201MB3394.namprd02.prod.outlook.com<https://groups.google.com/d/msgid/rbase-l/CY4PR0201MB3394923B6E454E5FD40A8A7BA0240%40CY4PR0201MB3394.namprd02.prod.outlook.com?utm_medium=email&utm_source=footer>. ________________________________ -- For group guidelines, visit http://www.rbase.com/support/usersgroup_guidelines.php --- You received this message because you are subscribed to the Google Groups "RBASE-L" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/rbase-l/CY4PR0201MB3394F7E2E0BD9605D50EA02DA0240%40CY4PR0201MB3394.namprd02.prod.outlook.com.
