Go under page settings and set your margins to zero. Dan Goldberg
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Kenny Camp Sent: Friday, February 20, 2004 11:23 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Label Help I recently installed a Zebra LP2844 and a TSC TDP-643 as network label printers and both required tweaking the printer driver on the local machine after attaching to the network printer. The Zebra is a little more expensive but I like it much better ( the same one as UPS uses) and it's driver & installation is better. To get it to print a test page from Windows Printer Properties ( or any label from 7.0) I had to reset the label size on each local machine and apply. We choose these direct thermal models because they use 4 X 2 labels at .008 per label and I could not find small labels on the internet for the Dymo for under .06. I don't know if the Dymo could use the labels we bought. We print 400 labels a day and save about $ 400.00 a month. Kenny Camp Oklahoma City, OK ----- Original Message ----- From: "Jeff Ward" <[EMAIL PROTECTED]> To: "RBASE-L Mailing List" <[EMAIL PROTECTED]> Sent: Friday, February 20, 2004 11:08 AM Subject: [RBASE-L] - Label Help > To All, > > From the recommendation on this list I went out and bought a Dymo 330 > turbo Labelwriter and its the best thing since sliced bread. > > However, when trying to print a 2 5/16 x 4 label from 6.5++ it wants to > start the label in the middle and print to the bottom, i.e. I only get my > return address and not the destination address. > > I believe I have set the dimensions correctly so what am I doing wrong? > > Thank you . > > Jeff > > >
