Good Morning
I have searched for the setting in outlook and the list archive files and have not come up with a solution. The problem with emailing from rbase does seem to be an ‘outlook’ problem. It seems the email must be sent before outlook will close. As long as I send the email I can resume my rbase session , but if I want to exit the email without sending it outlook will close, but the computer has to be reset. Is there someone (named Razzak) out there that might have a solution? Mike From: [email protected] [mailto:[email protected]] On Behalf Of Dawn Hast Sent: Thursday, April 09, 2009 12:34 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: email invoice as pdf Mike, This is not something that is controlled in RBase, it's a setting in Outlook. It's been a while since I had to do it, and I don't use Outlook now, so I can't point you to the exact location of the setting - but it's there. Actually, this has been brought up here before - so maybe a search of the archived messages will help if you can't see where to change the setting. Dawn -------------- Original message from "mike epstein sony viao office" <[email protected]>: -------------- Good morning once again Rachel I did as you suggested and did not set the allowed time. I still get the same results. It only happens when the email is not sent! Mike From: [email protected] [mailto:[email protected]] On Behalf Of Rachael Malberg Sent: Thursday, April 09, 2009 9:48 AM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: email invoice as pdf don't set the allow time just click 'allow'. ----- Original Message ----- From: mike epstein sony viao office <mailto:[email protected]> To: RBASE-L Mailing List <mailto:[email protected]> Sent: Thursday, April 09, 2009 8:57 AM Subject: [RBASE-L] - email invoice as pdf Good Morning I am using the eep that is found in the 2009 sat that creates a pdf doc and sets parameters for the plugin MAPIMail3.RBL to create an email to be sent. Before the email appears I get a message that asks for permission to access the outlook address book for ‘n’ minutes or deny access. I have set the permission for 1 minute. When the email appears, if it is not sent, my computer hangs up as if it is waiting for it to be sent and has to be rebooted. Should there be a line in the eep that would cancel or release the rbl? Mike
