And make sure to RSTYLE your code! Dennis McGrath
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of A. Razzak Memon Sent: Sunday, February 21, 2010 10:10 PM To: RBASE-L Mailing List Subject: [RBASE-L] - Re: Why won't this work during trace, butdoeswork during RUN? At 10:15 PM 2/21/2010, mjsmd wrote: >Dr. R, >Why would some code fail during a trace, but work during a run? Michael, Personally, I cannot comment unless I have full knowledge and details of everything. There are many factors which can result in a scenario like yours. A few suggestions: 01. Revisit the entire code, calling routines, from start to end. 02. Check CHARacter SETtings, including IDQUOUTES. 03. Verify the exact result of dotted variable used in your code. 04. In your original post, there was no source nor routine defined that created the ".vfromspec" variable. 05. You never mentioned the exact -ERROR- message. 06. SET MESSAGES ON and ERROR MESSAGES ON prior to running or TRAcing the code Hope that helps! Very Best R:egards, Razzak. --- RBASE-L =======================3D=======================3 D= TO POST A MESSAGE TO ALL MEMBERS: Send a plain text email to [email protected] (Don't use any of these words as your Subject: INTRO, SUBSCRIBE, UNSUBSCRIBE, SEARCH, REMOVE, SUSPEND, RESUME, DIGEST, RESEND, HELP) =======================3D=======================3 D= TO SEE MESSAGE POSTING GUIDELINES: Send a plain text email to [email protected] In the message SUBJECT, put just one word: INTRO =======================3D=======================3 D= TO UNSUBSCRIBE: Send a plain text email to [email protected] In the message SUBJECT, put just one word: UNSUBSCRIBE =======================3D=======================3 D= TO SEARCH ARCHIVES: Send a plain text email to [email protected] In the message SUBJECT, put just one word: SEARCH-n (where n is the number of days). In the message body, place any text to search for. =======================3D=======================3 D=
