In a message dated 4/10/2002 2:09:49 PM Eastern Daylight Time, [EMAIL PROTECTED] writes:
<< "-ERROR- No WHILE, SWITCH or IF blocks are open on current input source. (466)" Can anybody point me in the right direction as to what I should be looking for? I don't think it's as simple as leaving off a close-paren or a dangling "END%", but I could be wrong. If it's not, then what might it be? >> Steve, This has bit me a NUMBER of times when I miss am ending ' in a text variable or display, and I break out of the code. I've changed to using all titles and captions as dotted variables to keep this one form biting me. A good trace over and over will normally break it when you test it long enough, but something like set var vCap text = ' whatever the text may be without the last ' will give you that error and it's hard to catch if it's part of a seldom used while or if loop. I hope it helps Damon Damon D. Kaufman President Stalder Spring Works, Inc ISO-9002 / QS-9000 Certified 2345 S. Yellow Springs St. Springfield, Ohio 45506 Voice 937,322,6120 Fax 937,322,2126 email: [EMAIL PROTECTED] ================================================ TO SEE MESSAGE POSTING GUIDELINES: Send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: INTRO rbase-l ================================================ TO UNSUBSCRIBE: send a plain text email to [EMAIL PROTECTED] In the message body, put just two words: UNSUBSCRIBE rbase-l ================================================ TO SEARCH ARCHIVES: http://www.mail-archive.com/rbase-l%40sonetmail.com/
