A. Razzak Memon wrote:
At 04:51 PM 10/17/2004 -0400, Kayza Kleinman wrote:
I have an app file that I've codelocked to apx. It's been working fine, until I added one module. When I try to run it from the apx directly, I get a series of "unrecognized command" errors. When I run the same apx using a trace command, it works fine.
Kayza,
Remember, TRACE always runs as WHILEOPT OFF. (the DEFAULT is ON)
01. Check to make sure that the variables are pre-defined correctly with correct data types. (especially in your new block/module of code)
The first line in the block is
pause 1 using 'start'
The next few lines are setting variables using the form
set var vService text
All of these lines give me an error message. I actually put the pause line in to test whether the program even even gets to the block of code. Apparently it just doesn't work.
There is nothing that changes the CHAR SETtings, as far as I can see. Certainly no code or commands.02. Verify all database CHARacter SETtings in your command to match with the database.
Good luck!
Very Best R:egards,
Razzak.
--
Kayza Kleinman
Director, Nonprofit Helpdesk
Jewish Community Council of Greater Coney Island, Inc.
3001 West 37th Street
Brooklyn, NY 11224
Tel. 718 449-5000
Fax 718 946-8240
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
www.nphd.org <http://www.nonprofithelpdesk.org/>
“Putting Technology to Work For You”
