Can someone give me, in tech speak, the measurement of the allen bolt and hex nut that fits in Riv frames (Ram in this case)? Easier for me to ask hardware store than to lug mostly built bike into the store.
Have to cable up derailleurs and adjust, install saddle on pin and adjust; adjust bar; tape. And then somehow get some Stan's into the tubs. Hopefully this weekend ...!!! Oh: I swapped out the very graciously donated Veloces (thanks again, Tom) that didn't quite reach far enough (55..?) for some old Nashbar dual pivots (57) and these seem to reach fine except for the drive side rear, which is 1, perhaps 2 mm higher than optimum. I've double checked the slot position. Arch is centered. What gives? Next step to try another pad, but ...??? Thanks. PAMoore, off to the store (and PO) on the Green Riv. -- __________________________________________________________________________ BUSINESS BUILDING COME-ON!! $300 off a $600 resume + letter or Linked In profile package with referral that leads to full price sale! Refer two full-pay clients and you get the package for free! I am not cheap, but I am very good. So they say. Patrick Moore, Ph.D, MBA, ACRW, Albuquerque, NM, USA http://resumespecialties.com/index.html * [email protected] __________________________________________________________________________ -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en-US. For more options, visit https://groups.google.com/groups/opt_out.
