I have been testing my motors and track with a sabertooth dual speed
controller and C6C. Running the track up off the floor for a bit then
stopping I hear a sound similar to static electricity emanating from
the tracks, also after running the tracks in all directions after a
short time I seem to be getting some interference, tracks moving
without touching the joystick or running in the wrong direction than
it should be. Shutting things off then starting again seems to fix
this for a while , but it comes back. Is there a break in procedure I
should be doing and could it be static that is causing the
interference? should I run a grounding cord from the tank to the
ground? With the wires running right into the motor housing where
would I solder any capacitors to eliminate electrical noise? Sorry if
none of this makes sense my electrical knowledge is limited.
Any advice would be appreciated. Thanks Greg
--~--~---------~--~----~------------~-------~--~----~
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [EMAIL PROTECTED]
Visit the group at http://groups.google.com/group/rctankcombat
-~----------~----~----~----~------~----~------~--~---
