It is the same as the servos I used to test the setup. I used a microservo and a standard servo in channels 1 and 2 and they work fine. It is reasonable to assume that the other four channels are the same spacing and I seem to remember another email that said the spacing on servo pins is 0.100 in so we are in the ball park. The only problem that I can foresee is with Futaba servos that have a ridge along one edge of the connector. That ridge or fin is easily removed with either an xacto knife or a sprue cutter.
Ron Paul Hilton wrote: > Thanks Ron, but are you sure of the spacing? > > Paul H. > > ----- Original Message ----- > From: "Ron" <[email protected]> > To: <[email protected]> > Sent: Friday, March 20, 2009 9:45 AM > Subject: [TANKS] Re: Vex signal splitter. > > > >> Paul, >> >> A three pin header will work as a gender changer. They are available >> from various electronic supply outlets and some robotics places also >> carry them. I am not sure where I got mine, but Pololu sells them as >> breakaway strips of 100 so you can break off 3 at a time. >> >> Ron >> >> Paul Hilton wrote: >> >>> Just got my Vex signal splitter today. I'm not happy. The Vex >>> servo's seem to have male plugs, unlike the Futaba servo's that have >>> female ones. Help, guys. >>> >>> Paul H. >>> >>> > > > > > > --~--~---------~--~----~------------~-------~--~----~ You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat -~----------~----~----~----~------~----~------~--~---
