Paul Hilton wrote:
> Got the headers today! Thanks Frank! You were right about the spacing. As
> Ron pointed out, there is a tab on the signal side of the Futaba servo that
> keeps it from being inserted. I'll remove the tab today. I don't know if
> the pin arrangement is the same.
Most servos now use the Futaba standard which is:
Signal - the "inside" pin, closest to RX circuit
(Futaba = white, Hitec = Yellow, Airtronics = Blue)
+V - center pin on connector
(All brands = Red)
GND - the "outside" pin, closest to edge of RX board
(All brands = Black)
With that arrangement, if you reverse the connector accidentally
(reversing Signal and GND), the servo will either sit still or chatter a
little, but you won't blow the RX or servo. If, however, you reverse +V
and GND wires, the magic smoke will be released from either the RX,
servo or, for those lucky few, both.
Frank P.
--~--~---------~--~----~------------~-------~--~----~
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat
-~----------~----~----~----~------~----~------~--~---
