Also, 10 AWG is "ok" from the speed controller to each motor, but you
should run separate lines from the battery/fuses/switch to the speed
controller channels because of the combined current draw of the EVs.
Frank P.
On 1/5/2011 12:30 PM, HV wrote:
1) Gear ratio: 6:1
2) Drive wheel diam: 4.25 inch
3) Speed control: Robot Solutions, 160 A (I think)
4) Wire gauge: 10 AWG
--
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat
