The biggest reason I'm wanting to calculate RPM's is to figure out my gearing. 
If I've got a 6.3 in diam wheel, and an 11 tooth wheel on my motor, how large 
does the wheel the motor drives via the chain have to be?I don't need anything 
exact, but I also don't want to have to buy 3~4 different sprockets to try to 
get a decent road speed. 
I'll hook it up to the existing drive wheel, and just do a tape-and-10-second 
count and calculate it from there (figuring high, as the increased load of my 
vehicle will slow it down somewhat).
Ah, the joys of being a total newbie! :-)
> Date: Wed, 18 Apr 2012 14:28:41 -0400
> From: [email protected]
> To: [email protected]
> Subject: Re: [TANKS] Motor swap anyone?
> 
> Seriously, if you're only worried about "relative" speed (e.g., Is this 
> motor faster than another? or What speed range does this ESC provide?), 
> then you can attach the axle motor being tested to another motor (e.g., 
> tachometer) and then read the voltage from the tachometer motor to 
> measure the speed.  We used to do such tests a lot to select motors for 
> driving warships around.  By adding a friction wheel to the setup and 
> measuring the current drawn by the motor being tested, you can determine 
> the speed/current vs. voltage performance curves for the motors being 
> tested under varying loads.
> 
>       Frank P.
> 
> Norman James wrote:
> > Speaking of which... what's a good way to measure RPM without any fancy
> > equipment?
> 
> -- 
> You are currently subscribed to the "R/C Tank Combat" group.
> To post a message, send email to [email protected]
> To unsubscribe, send email to [email protected]
> Visit the group at http://groups.google.com/group/rctankcombat
                                          

-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to