Hello -
I have another 'Machining 101' question. I have a parting tool for my
mini-lathe just like the one shown below. The bit sits in it a few degrees
off from vertical. When I use it, the parted piece has a convex,
cone-shaped, face. I want a straight, clean, cut. Is this the normal
construction for parting tools ? Am I using it wrong ? Is this the wrong
parting tool for me ?
I appreciate any advice.
Thanks a lot,
Doug
HF_tool.jpg (20563 bytes)
--
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat
<<image001.jpg>>
