Not necessarily reduction in both parts. Those 72-tooth sprockets (that look like circular saw blades) give a ratio of 1:6.545. They were the largest I could find for #25 chain.
The pulleys I can fit on the front and middle shafts would allow as low as 1:9.164 and as high as 1:3.273. As you can see I used every inch of available space inside the hull and then a little more. For my first installation I am using the nominal rated speed of the motors and aiming for scale replication of the actual top speed. I'll drop it down if it makes traverse aiming too twitchy. On Monday, September 17, 2012 7:24:42 AM UTC-4, TyngTech wrote: > > Good work. Nice to see a good ole' fashioned double reduction > transmission. > -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
