Mike, I can't tell from the pic but are the tensioner screws pulling up on the tension pulley shaft or do they extend through the shaft and push down on the bottom of the hull? If pulling up, I'm afraid those top brackets will bend under the force you will need to get adequate tension.
ST On Monday, September 17, 2012 9:58:48 AM UTC-4, Mike Lyons wrote: > > Not necessarily reduction in both parts. > > Those 72-tooth sprockets (that look like circular saw blades) give a ratio > of 1:6.545. > They were the largest I could find for #25 chain. > > The pulleys I can fit on the front and middle shafts would allow as low as > 1:9.164 and as high as 1:3.273. > > As you can see I used every inch of available space inside the hull and > then a little more. > > For my first installation I am using the nominal rated speed of the motors > and aiming for scale replication of the actual top speed. I'll drop it > down if it makes traverse aiming too twitchy. > > > On Monday, September 17, 2012 7:24:42 AM UTC-4, TyngTech wrote: >> >> Good work. Nice to see a good ole' fashioned double reduction >> transmission. >> > -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
