I just installed this SqD HL Combination Service entrance/ meter combo Part # RC816D200CH. Gregory, I sent you photos (ck yer junk box) anyone else interested in photos please contact me off list. TUMP On Feb 17, 2016, at 6:15 PM, Gregory Seelhorst wrote:
> Thank you for your contributions. The meter/main Combo is the preferred > solution here. I do like the Milbank solution with longer Feeders. > > Has anyone used the SC816F200PS Square D all-in-one? > Square D (Schneider) is advertising this as a "Homeline Solar-ready > Combination Service Entrance" where it can accomodate CTs. > > Greg Seelhorst > NABCEP PV Installation Professional #092907-16 > > > > On Wed, Feb 17, 2016 at 2:39 PM, Dave Tedeyan <dtede...@taitem.com> wrote: > It is not Square D, but a Milbank U5168-XTL-200 would do the trick. > > Cheers, > Dave > > > -- > > Dave Tedeyan > Project Engineer > > Taitem Engineering, PC > 109 S. Albany Street, Ithaca, NY 14850 > Voice: (607) 277-1118 x121 > www.taitem.com > > On Wed, Feb 17, 2016 at 3:31 PM, Patrick A. Shortell <pshorte...@gmail.com> > wrote: > Hi Gregory > If your installing a new load center > Try inserting a 2" "C" condulet > Ahead of the service panel > I'm assuming pvc conduit from meter to panel > Install solid core 200:5 ct's while you pull your cable through > Route the ct leads into the panel along with the phase conductors > Or if you have a meter main > Most have bolted buss connections that you can open and if you stagger the > ct's and support them with a few cable ties > That could work > But > Your meter probably requires voltage sense and meter power conductors so > nippling the meter to the panel might be a better solution just so you don't > have to install additional oc protection in the meter main > Which might be sketchy > Hope I understood your question > Pat > > Patrick A. Shortell > Licensed Master Electrician > Certified Solar Installer > 71 Oregon Street > Long Beach N.Y. 11561 > Www.thesolarstorehouse.com > > > On Feb 17, 2016, at 2:29 PM, jerrysgarage01 <jerrysgarag...@gmail.com> wrote: > >> Can you get a meter main with only one breaker and then get a distribution >> panel and put all all loads there >> >> >> Sent via the Samsung Galaxy S™ III, an AT&T 4G LTE smartphone >> >> >> -------- Original message -------- >> From: Gregory Seelhorst >> Date:02/17/2016 6:23 AM (GMT-10:00) >> To: RE-wrenches >> Subject: [RE-wrenches] Optimal 200 or 225 Amp Square D MSP All-in-One meter >> for CT Clamps >> >> Wrenches - >> >> Does anyone know of a good spec for a 200 or 225A Square D Main Service >> Panel which has feeders between the meter and Main Disconnect and would be >> ideal for 150A CT clamps for monitoring whole house consumption? >> >> I'm finding most MSPs have a short, flat bus between the meter and Main >> Disconnect which requires the Rigowski Coil (requiring more expensive and >> unreliable hardware). >> >> Thank you for your help in advance. >> >> Regards, >> >> Greg Seelhorst >> NABCEP PV Installation Professional #092907-16 >> >> >> _______________________________________________ >> List sponsored by Redwood Alliance >> >> List Address: RE-wrenches@lists.re-wrenches.org >> >> Change listserver email address & settings: >> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org >> >> List-Archive: >> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html >> >> List rules & etiquette: >> www.re-wrenches.org/etiquette.htm >> >> Check out or update participant bios: >> www.members.re-wrenches.org >> > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > t...@swnl.net www.SWNL.net > Solarwinds Northernlights > Serving Mid Coast Maine & Northern California > 207-832-7574 Cl. 610-517-8401 > > Blair "TUMP" May > ******** MAINE'S CHARTER ******** > NABCEP "Certified PV Installer" > > ******** MAINE'S CHARTER ******** > Trace Xantrex "Certified" Dealer / Installer" >
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org