Hi Daryl, You might check out S-5 VersaBrackets and RibBrackets:
http://www.s-5.com/clamps/index_71.cfm http://www.s-5.com/clamps/ribbracket/index_5336.cfm -August -----Original Message----- From: RE-wrenches [mailto:[email protected]] On Behalf Of [email protected] Sent: Sunday, August 28, 2016 5:13 AM To: RE-wrenches Subject: [RE-wrenches] Metal roof multi-fastener attachment Hi all, I have some possibilities of reasonable size commercial jobs where the buildings have "corrugated" type roofs with purlins run underneath which are worst case 16 gauge steel. On steel roofs I typically use #14 Marutex stainless screws but in this case the job is in the Caribbean and there is a high risk of hurricanes. We use Snap N Rack but their steel roof attachment has only a single screw attachment point. What I am looking for is a metal roof attachment that will mate with Snap N Rack materials and that has multi attchment points at each attachment point. It would go on the flat area of the metal roof between the "corrugations". Does anyone have any suggestions? I can get the Marutex screws with rubber gaskets. Thanks, Daryl _______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/[email protected]/maillist.htm l List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org _______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/[email protected]/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
