Hi Jason - We've used Unirac SunFrame for similar applications. I'm not certain that the shared rail can accommodate the slight different in angle between module rows due to the curve, but it might be worth checking out if you haven't already:
https://unirac.com/sunframe/ August On Thu, Feb 7, 2019 at 6:06 AM Jason Szumlanski < [email protected]> wrote: > Hi all, > > I'm looking for some ideas for attaching modules to a curved carport > system. I attached a concept drawing. I'm pretty dead-set on through > bolting to the frames, but bottom clips would probably work if using an > off-the-shelf rail system. Any products or picture you can supply would be > very helpful. > > The uprights pictured are already determined. It's a 20' radius curve. I'm > assuming it will be steel tube bent to that radius. The total length will > be much longer than what is pictured. The general contractor is willing to > entertain any welded or bolted solution for the structure. > > Thanks! > > Jason Szumlanski > Florida Solar Design Group > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/[email protected]/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > >
_______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/[email protected]/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
