Hello Kirpal Hello Wrenches This can be accomplished using the Mate3(s) and Flextime. Flextime allows up to 3 modes in a 24 hour day. Flextime uses a 24 hour clock to instruct a system to switch modes based on time. A good knowledge of the modes and how they work is helpful. Results may vary depending on solar vs loads. Below is a picture of a system set up to achieve your request. Adjust the times to suit your individual needs. The setting below are as follows 1800 to 1830 Grid Tied and sell enabled 1830 to 0700 Grid Zero (no sell and no charge from the grid) 0700 to 1800 Back Up (allowing the unit to pass through and charge) Again a good knowledge of how the modes function and the charging triggers (Re-Bulk and Re-Float) is helpful. One of the advantages is this can be done via optics so fine tuning can be accomplished by monitoring the system over time as it goes through the various sequences.
[cid:[email protected]] I hope this helps. Take Care All From: RE-wrenches <[email protected]> On Behalf Of Kirpal Sent: Thursday, February 4, 2021 8:22 AM To: RE-wrenches <[email protected]> Subject: [RE-wrenches] grid sell back time settings on Outback systems Hi Folks.... We have a scenario where we would like to control when our system sells power back to the grid. Basically, we only want to sell back while the sun is shining. We would like to stop selling based on programmed clock settings. I know in HBX mode we can control when we buy from the grid, wondering if anyone knows how to control if and when we sell to the grid, separate from voltage set points. In this situation we basically don't want to sell hydro power back at night. We can create our own relay controls to prevent if we need to, but hoping someone has a Mate controller based programming solution. I can't seem to find it and at first glance Outback tech support didn't have an answer...It was a new tech support guy I spoke with and he was going to do some research and get back to me. 100 Thanks! Sunny Regards, Kirpal Khalsa Oregon LRT#25 Oregon Solarworks LLC www.oregonsolarworks.com<https://protect2.fireeye.com/v1/url?k=49430a66-16d832a0-494003ed-8656ebba2f0b-766b497cb6918bea&q=1&e=76ee1199-0f8b-49d3-a655-327a42c2fc49&u=http%3A%2F%2Fwww.oregonsolarworks.com%2F> 541-299-0402 This email and any attachments may contain confidential information that is intended only for the recipient(s). If you have received this email in error, please notify the sender and delete it from your system. Any views or opinions presented in this email are solely those of the author and do not necessarily represent those of the company or its affiliates. This email does not constitute an agreement to conduct transactions by electronic means and does not create any legally binding contract or enforceable obligation in the absence of a fully signed written contract. The recipient should check this email and any attachments for viruses. The company accepts no liability for any loss or damage caused by software viruses. If you are the intended recipient and you do not wish to receive similar email(s) from us in the future then please notify the sender. Please consider the environment before printing.
_______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/[email protected]/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
