Shane, >What would be the best glue for me to use to glue a clear plastic airline >tube connector (the kind that goes into airstones) into a piece of PVC? I am Drill a hole that is exactly the same diameter as the airline, apply some PVC solvent to the hole, let sit for about 30 seconds, then push the airline in. The solvent dissolves the PVC, slip the airline in, and then it is stuck when it sets. Not actually glued, but jammed in, in effect. >Thanks. Do you recommend I incorporate a high pressure check valve into the >line (they are expensive) or should a normal check valve do the trick? I Normal check valve are able to handle it. Be careful over time though, as some of the cheaper ones you can get will fail. For safety I have two inline. Catch ya, DBW | The Caretaker, OZ REEF Marine Park Melbourne | http://ozreef.org/ Australia | [EMAIL PROTECTED] -------------------------------------------------------------------------- When the only tool you own is a hammer, every problem begins to resemble a nail. ________________________________________ LEAVING THE LIST ================ To stop receiving messages you will need to send a message to [EMAIL PROTECTED] with a command to remove you from the list. The list manager controls who belongs to the list. For example: -------------------------------------------------------------- From: John Doe <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] Subject: <not needed> UNSUBSCRIBE --------------------------------------------------------------
