Do you need the sampler simply to feed into a service monitor for deviation measurements etc ?
If so, just wrap a three or four turn loop of wire around the coax feeding your dummy load, and connect to test leads. Bob ----- Original Message ----- From: "nj902" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, November 19, 2003 5:41 PM Subject: [Repeater-Builder] Re: RF Signal Sampler > --- In [email protected], "nj902" <[EMAIL PROTECTED]> wrote: > "...You might look at the RF Industries variable signal sampler > which is rated from 20-3000 MHz, 500 Watts power, 20-80 dB > coupling. This device comes with type 'N' connectors which can be > changed using the RF Industries Unidapt connectors. > > The part number is RFA-4059-A. > > _______________________________________________________________ > > Even cheaper here: http://www.rfparts.com/unidapt.html > > As low as $41.00 if you already have a unidapt kit. > > > > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
