what i have here is the following: J311 to repeater wire harness from transmitter Pin 6 hi / lo pwr 9 xmit audio Pin 18 At Level Card 10 PTT Pin 19 At Level Card 25 TP 302 27 TP 303 13 Xmit B+ 17 Rec B+ (not used) 19 B+ IN 22 CG In J310 Pin 22 At Level Card 23 Thermal R400 24 Pwr Sense 35 B+ 28 GND 33 GND
so for the controlle u would need the pin 10 PTT Pin 9 Tx Audio pin 22 CG In now these can be foud at the level card Receiver pinouts found at the level card are as follows Pin 20 Call Gaurd Audio Pin 11 At Level Card 21 Squelch GAte Pin 12 At Level Card 11 Audio Output Pin 8 At Level Card 12 Audio Input Pin 7 At Level Card 5 Squelch Control Pin 5 At Level Card 8 Local Audio Output To Local Spkr the local connection pinout are as follows.. Speaker to pin 8 on receiver Mic Audio to pin 13 of the Level card (mic audio switch U701C) PTT to pin 14 of level card (transmit switch (Q709) than to the invertor Q708 I hope the above info would help you out.. ----- Original Message ----- From: "ki4bmd" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, December 12, 2003 7:39 AM Subject: [Repeater-Builder] EF Johnson 1000 Repeater UHF HELP > looking for the pinout or wiring for a EF Johnson UHF Base 1000 > Repeater,I want to remove the controller card from it and use a cat > controller.not sure of where to pick up my connections for > RX Audio > TX Audio > Cor > ptt > CtCSS > and ground > after removing the controler card in the johnson > so I need the schm for the area to pick up those points > Thanks if you have them steve KI4BMD > > > > > > > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > > --- > [This E-mail scanned for viruses at TNWEB LLC] > > --- [This E-mail scanned for viruses at TNWEB LLC] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
