Try adding a pull-down resistor to the cas line about 10k would do to be certain the controller is not floating, you may want to try this on the correct ctcss input switch also to prevent bouncing.
Rick - VA3RZS/Charlotte - VA3CMR wrote: > > Ok Guys and Gals > > I have a little problem here > I am getting a crap load of noise off my repeater > > I have a Linkcomm Moto squelch > and a RLC2A controller > > with a good ol Harris radio > > now here is the problem > > when I key the radio I can talk and an bad noise follows then the tail > drops > > will I thought it was the repeater BUT I look at the squelch and the > light goes out after I unkey but the noise is still there or a couple of > sec. > > I thouht it was where the repeater is so I added PL > > again PL and COS drop and still have that darn noise > > could this be coming from my power supply ? via the controller ? > the radio controller PL pannel are all on the same PS > > every thing is drawing about 12 amps out of a 30 amp PS > > any one have any idea what might be going on ?? > > Thanks > > Rick Szajkowski VA3 RZS > Charlotte Darby VA3 CMR > Node Owners of IRLP Node 2120 > Lakefield Ont Canada > > > > Yahoo! Groups Links > > To visit your group on the web, go to: > http://groups.yahoo.com/group/Repeater-Builder/ > > To unsubscribe from this group, send an email to: > [EMAIL PROTECTED] > > Your use of Yahoo! Groups is subject to: > http://docs.yahoo.com/info/terms/ -- 73...Clark Beckman N8PZD Pursuant to U.S. Code, title 47, Chapter 5, Subchapter II, ß227, "Any and all nonsolicited commercial E-mail sent to this address is subject to a download and archival fee of $500.00 U.S.". E-mailing denotes acceptance of these terms. Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ To unsubscribe from this group, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
