I would try first to clean  all the boards where they plug into the back
board.
also the connections on all the boards to the sub boards  also check the 9.6
volt fuse
good luck


----- Original Message ----- 
From: "rtoplus" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Saturday, January 17, 2004 3:05 PM
Subject: [Repeater-Builder] [EMAIL PROTECTED] Micor


> I'm buffalo'd  (not unusual for me).  Got a UHF (462 mhz) unified
> micor...was working fine a couple of weeks ago...it's just been
> siting in my office unplugged.  I finally got around to tuning the
> duplexer today and when I connected everything back up...nuttin.  I
> can't key up using the station control switch.  When bypassing the
> PA, and hooked the exciter (low level amp out) to the watt meter (5w
> slug), there is no reading when the station is keyed, turned on or
> off, or when I key it up with my hand held.  On my service monitor,
> I can pass the pl tone to the repeater and hear it through my
> handheld on the repeater output freq.  There is no external
> controller on this by the way.  I plugged in the test set and here
> are the readings...
>
> switch 1...0
> switch 2...26
> switch 3...36
> switch 4...32
> switch 5...starts out at 10 when the unit is cold and then drops to 4
>
>
> Again, when the unit is keyed, nothing changes.  My hand held picks
> up a signal also when the unit is just sitting there.  If I key my
> handheld, I can hear a squelch tail.  The exciter gets fairly warm
> too.  Any ideas?
>
> Thanks
> Bob, GMRS WPVV845, Amateur KG4WAD, LMRS WPXC892
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
>  http://groups.yahoo.com/group/Repeater-Builder/
>
> To unsubscribe from this group, send an email to:
>  [EMAIL PROTECTED]
>
> Your use of Yahoo! Groups is subject to:
>  http://docs.yahoo.com/info/terms/
>
>




 

Yahoo! Groups Links

To visit your group on the web, go to:
 http://groups.yahoo.com/group/Repeater-Builder/

To unsubscribe from this group, send an email to:
 [EMAIL PROTECTED]

Your use of Yahoo! Groups is subject to:
 http://docs.yahoo.com/info/terms/ 


Reply via email to