What did this test point read prior to changing the frequency? If you did not verify operation at (or near) the original frequency, you may have a component failure.
73 Glenn WB4UIV At 02:39 PM 01/26/04 +0000, you wrote: >I am having problems getting my GE Mastr II VHF exciter to tune >properly. All goes well until I start tuning T110. I have my meter on >pins 5 (-) and 6 (+) but get no reading at all. I have adjusted T110 >all the way through but still see no reading. When I ground my meter >to chassis ground I get about 9 volts here. Does anyone have any >ideas what I might be doing wrong? I am fairly new to repeater >building and have not seen this problem yet. > >Thanks > >Jay > > > > > > >Yahoo! Groups Links > >To visit your group on the web, go to: > http://groups.yahoo.com/group/Repeater-Builder/ > >To unsubscribe from this group, send an email to: > [EMAIL PROTECTED] > >Your use of Yahoo! Groups is subject to: > http://docs.yahoo.com/info/terms/ Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ To unsubscribe from this group, send an email to: [EMAIL PROTECTED] Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
