Hi Mark, Many Goverment Agencies received their MSR Service Manuals in binder form.
Please find the manual numbers and try to order them direct or the obvious Ebay route. Worse or the preferred last case (for me), I could and would be willing photocopy the UHF Receiver tune up section, but there will be a large delay before I can get that done. Good luck with your MSR Project. cheers skipp www.radiowrench.com > "Mark Tomany" <[EMAIL PROTECTED]> wrote: > OK, thanks Skipp. I'll look there for the manual numbers. Ours was not a > special build, but rather one for 460 MHz that was tuned down. > > What I currently have is a 3" binder that contains a number of different > sections, including receiver; transmitter; then special options, etc. My > manual has the transmitter info for both VHF and UHF, but only contains the > page sheets for the VHF receiver. Oh well... > > Thanks again! > > 73 de Mark - N9WYS > > -----Original Message----- > From: skipp025 [mailto:[EMAIL PROTECTED] > Sent: Tuesday, April 20, 2004 11:46 AM > To: [email protected] > Subject: [Repeater-Builder] MSR2000 Manuals > > Hi Mark, > > There are three basic manuals for the MSR Series of > repeater/base stations. First is the control and > operation manual, which has the back-plane board > and control module information. > > The VHF Manual has a green strip on the cover and > contains the Transmitter/Receiver information. The > power supply information is also in the VHF Manual. > > The UHF Manual has a blue strip on the cover and > has the RF information for the UHF strips and the > internal duplexer. > > I have at least two other non standard MSR Manuals, > which are from as-built projects. > > What I call Canadian MSR's are lower rf power out > and contain a consolette base type power supply, > vs the power hungry high power US dc supplies. > > Part numbers are probably on the repeater builder > web site. The special as-built manuals are probably > not available. > > cheers > skipp > > www.radiowrench.com > > > "Mark Tomany" <[EMAIL PROTECTED]> wrote: > > Skipp - can you advise the part numbers for the > > manual sections for the UHF receiver? My manual > > has the transmitter stuff, but the receiver stuff is > > all for the VHF unit. I'm going to try to get > > them from Motorola... If I'm not successful, do > > you - or anyone else here - have the UHF receiver > > manual sections available for copy? > > > > Of course, I'll reimburse for any copying fees > > and postage.... > > > > Thanks, > > Mark - N9WYS > > > > > > > Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
