Hi all, You may remember the thread on audio quality a few weeks back. One topic was a replacement module for the stock audio processing circuitry which is a major cause of limited bandwidth from some manufacturers and models of equipment used to build repeaters and links from. I and happy to announce the release of the prototype audio processor (clipper/filter) module from Repeater Builder.
This product is being offered for sale as a prototype. Although it has been thoroughly tested by the designer and Repeater Builder, and changes implemented to insure its operation, this board will likely not be a final product. This simply means that we will likely do a board revision in the future *if* there is enough interest in this product. The current board has mounting holes that are uncomfortably close to solder pads, and extreme care must be exercised when mounting the unit so you don't short out the circuitry. We would also like to add connectorization to the next board revision. It should be noted that these shortcomings in no way affect the operation of the board. We feel the circuit is perfected, just the layout needs some work. Orders are handled via email as we only have 12 boards for sale at the time of this writing. The board comes with instructions for set-up and a basic schematic for troubleshooting. Go here for more details and ordering information: http://www.repeater-builder.com/products/processingorder.html Kevin Custer Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
