The link was a blank page. Chuck WB2EDV
----- Original Message ----- From: "Kevin Custer" <[EMAIL PROTECTED]> To: "Repeater Builder" <Repeater-Builder@yahoogroups.com>; "GE List" <[EMAIL PROTECTED]>; "GE-Mastr II List" <[EMAIL PROTECTED]>; "Motorola-User List" <[EMAIL PROTECTED]>; "Micor List" <[EMAIL PROTECTED]> Sent: Saturday, April 24, 2004 11:16 PM Subject: [Repeater-Builder] New Product, Audio Processing Module for Repeaters and Links. > Hi all, > > You may remember the thread on audio quality a few weeks back. One > topic was a replacement module for the stock audio processing circuitry > which is a major cause of limited bandwidth from some manufacturers and > models of equipment used to build repeaters and links from. I and happy > to announce the release of the prototype audio processor > (clipper/filter) module from Repeater Builder. > > This product is being offered for sale as a prototype. Although it has > been thoroughly tested by the designer and Repeater Builder, and changes > implemented to insure its operation, this board will likely not be a > final product. This simply means that we will likely do a board > revision in the future *if* there is enough interest in this product. > The current board has mounting holes that are uncomfortably close to > solder pads, and extreme care must be exercised when mounting the unit > so you don't short out the circuitry. We would also like to add > connectorization to the next board revision. It should be noted that > these shortcomings in no way affect the operation of the board. We feel > the circuit is perfected, just the layout needs some work. > > Orders are handled via email as we only have 12 boards for sale at the > time of this writing. The board comes with instructions for set-up and > a basic schematic for troubleshooting. > > Go here for more details and ordering information: > http://www.repeater-builder.com/products/processingorder.html > > Kevin Custer > > > > > > > > Yahoo! Groups Links > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/