Is that board rebuildable ?? MH ----- Original Message ----- From: "Joe D" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, September 01, 2004 8:39 AM Subject: [Repeater-Builder] Re: Astron Power Supply Crobars
> Allow me to elaborate. > > I have an RM-35M. It has been in continuous repeater service for > more than 10 years without a hiccup. > > Recently our hosts did some electrical work in the building. They > installed new elevator motors and emergency power. We are now > connected to the emergency power through a very large (~60lbs) ferro- > resonate transformer. > > The elevator motors and controllers are not in the same room as the > repeater, but the main power passes through our room. The repeater > has been in the same location without any problems from the elevators > for 30-years. > > After the change the RM-35M started crowbaring once or twice per day. > > I replaced the power supply with another RM-35M. It has been running > fine for a couple of weeks now. > > The original power supply, plugged in on my workbench, with no load, > will crowbar after running for 3 to 12 hours. > > So, will someone tell me about this replacement regulator board of > Skipp's? > > JoeD, N2UF > > > > --- In [email protected], Joe <[EMAIL PROTECTED]> wrote: > > I have an RM-35 that has run for years without the > > crowbar ever operating. Check the output voltage, > > check it for AC ripple. > > > > 73, Joe, k1ike > > > > --- Joe D <[EMAIL PROTECTED]> wrote: > > > > > I have an Astron RM-35M that runs for a few hours > > > and > > > then crowbars. > > > > > > > Yahoo! Groups Links > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
