Kevin, I downloaded the file from the location listed and checked the diagram out.
I have a question regarding the bottom of the 2 pictures. 1. If the level of either input is changed, will this alter the level of the other input? 2. can one add extra inputs to the circuit, I want to use an circuit that will allow 4-6 inputs with 2 outputs. 3. I would like to look at using a IC switch on the above 6 inputs, that allow the inputs to be switched when required? Believe the IC would be a 4040, but I would have to double check. I know some repeater controllers use this chip to control the audio paths. I will attempt to draw a circuit of my thoughts if this would help, but I think the above may explain enough. Regards Kevin, ZL1KFM ----- Original Message ----- From: "Kevin Custer" <[EMAIL PROTECTED]> To: <[email protected]> Cc: <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Friday, September 10, 2004 7:17 AM Subject: Re: [Repeater-Builder] Audio mixer circuit > Steaven Rogers, W4YI wrote: > > >I am needing to mix two RX audio lines to feed into a CAT300DX > >controller. I think I may have found a circuit that will work, but I > >would like to see ideas from others. > > > > http://www.repeater-builder.com/tech-info/pix/link_circuits.gif > > Bottom of image - only need one output pot for your application. > > Hope this helps... > Kevin Custer > > > > > > > Yahoo! Groups Links > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
