Looking to replace a short (~1600') wire link between control site and
transmitter with an RF link. There are many inexpensive RF modules
available to run at 927/928 and seem likely candidates but I'm
somewhat concerned with ISM and Part 15 devices that also "share" 900
mhz.
The area is lightly populated but the transmitter site (link receiver)
faces a populated area and many (most) of the 900 modules I've looked
at natively tune into the 900 ham allocation - just set the freq.
Has anyone had actual experience using 900 as a link? Good? Bad?
Microwave ovens? Cordless phones? Baby monitors? Wireless cameras?
Whatever?
Thanks in advance,
Bill - WB1GOT
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
