|
Matt, it is likely the audio output transistor. ER41 comes in two versions.
One has about 2 watts of audio from one transistor. The other has two
transistors and about 10 watts out. In both cases the transistors are mounted
underneath the receiver on a tab on the heatsink. If yours has tone, you will
have to loosen the tone board to see the transistor(s). I have seen the one
transistor version fail where it will still have some audio. The two transistor
version sometimes has a small resistor in the bias circuit that changes value.
In this case, the audio will usually also be quite distorted. I think it is 240
ohms or so. I don't have the diagram here now. Seems like the metering socket
has a pin to check the bias on the output transistor. If it cannot be adjusted
into specs, the transistor or the resistor are the most likely suspects from my
experience, although I have seen other problems.
nd where to look. I have not done any trouble shooting at this point, but thought by chance if is was a common problem someone could point me in the right direction. Thanks. Mathew Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/ Dave Baughn
Director of Engineering The University of Alabama Center for Public Television and Radio Box 870150 Tuscaloosa, Alabama 35487 205.348.8622 cell 205-310-8798 NEW EMAIL [EMAIL PROTECTED] Yahoo! Groups Links
|
- Re: [Repeater-Builder] GE MASTR ER41 Receive... Dave Baughn
- Re: [Repeater-Builder] GE MASTR ER41 Re... Mathew Quaife
- [Repeater-Builder] Transsistor Sub?... bob55
- Re: [Repeater-Builder] Transsis... Mark Holman
- Re: [Repeater-Builder] Transsis... Neil McKie
- Re: [Repeater-Builder] Tran... Ted Bleiman K9MDM - MDM Radio
- [Repeater-Builder] Repeater Interferenc... W2JRT - Jeff
- Re: [Repeater-Builder] Repeater Int... Mike WA6ILQ
- Re: [Repeater-Builder] Repeater... Jeff Thomas
- Re: [Repeater-Builder] Repe... Mark Holman

