Ok found all of that, this is the E version.  I checked the voltage on the transitor, its about 1/2 of what it should be.  I just wonder if this low audio will hamper the use of it any in the repeater situation.  The sensitivity of the receiver is excellent, at .17 Uv at 12 DB.  I am using the discriminator audio portion of it.  What do you think.  Is it worth the trouble to repair it, since I will never need to use the audio output of the receiver.
 
Mathew

Matt, it is likely the audio output transistor. ER41 comes in two versions. One has about 2 watts of audio from one transistor. The other has two transistors and about 10 watts out. In both cases the transistors are mounted underneath the receiver on a tab on the heatsink. If yours has tone, you will have to loosen the tone board to see the transistor(s). I have seen the one transistor version fail where it will still have some audio. The two transistor version sometimes has a small resistor in the bias circuit that changes value. In this case, the audio will usually also be quite distorted. I think it is 240 ohms or so. I don't have the diagram here now. Seems like the metering socket has a pin to check the bias on the output transistor. If it cannot be adjusted into specs, the transistor or the resistor are the most likely suspects from my experience, although I have seen other problems.





nd where to look.  I
have not done any trouble shooting at this point, but thought by
chance if is was a common problem someone could point me in the
right direction.  Thanks.

Mathew









Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/




 
Dave Baughn
Director of Engineering
The University of Alabama
Center for Public Television and Radio
Box 870150
Tuscaloosa, Alabama 35487
205.348.8622 cell 205-310-8798
NEW EMAIL [EMAIL PROTECTED]














Yahoo! Groups Links

Reply via email to