I think you're describing the difference between a UHF Micor receiver
that came out of station versus one from a mobile. On the station
receivers, there is an extra shield on the solder side of the board that
covers up the area around the LO multiplier chain. Unless you have a
problem related to LO leakage causing you problems somewhere else, it's
probably no big deal.
--- Jeff
-----Original Message-----
From: Kevin Custer [mailto:[EMAIL PROTECTED]
Sent: Sunday, December 05, 2004 1:31 PM
To: [email protected]
Subject: Re: [Repeater-Builder] Micor RX Strip TLE8032A Shield Missing??
Adam C. Feuer wrote:
Hello Kevin & All,
I have a Micor RX Strip model TLE8032A and noticed that a shield is
missing from being installed over the multiplier coils. I could have
sworn that another RX strip that I had (now in service on a mountain)
had that shield. It does NOT appear to have been removed but never
installed at the factory.
Has anyone else seen this before? Also, will there be any difference in
performance?
All shields must be in place for the stages to have isolation and tune
properly. Can you take a picture of the receiver and send it to me?
I have many spare shields and will offer to give you the one you need.
Kevin
_____
Yahoo! Groups Links
* To visit your group on the web, go to:
HYPERLINK
"http://groups.yahoo.com/group/Repeater-Builder/"http://groups.yahoo.com
/group/Repeater-Builder/
* To unsubscribe from this group, send an email to:
HYPERLINK
"mailto:[EMAIL PROTECTED]
"[EMAIL PROTECTED]
* Your use of Yahoo! Groups is subject to the HYPERLINK
"http://docs.yahoo.com/info/terms/"Yahoo! Terms of Service.
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.289 / Virus Database: 265.4.6 - Release Date: 12/5/2004
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.289 / Virus Database: 265.4.6 - Release Date: 12/5/2004
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.289 / Virus Database: 265.4.6 - Release Date: 12/5/2004
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
