Re: [Repeater-Builder] 600 - 10k ohm Interface

[John J. Riddell]

Kevin,  I just built one here for our Church for a DVD player, "Stereo" to an 10 K input on a "Mono" amp.   You can use half of what I did......   From the 600 ohm OP put a 4.7K resistor to the top of a 5 K trim pot. The bottom of the trim pot goes to ground.   From the centre of the trim pot put a 4.7 K resistor to the 10 K input.   Adjust the pot for the desired level going in to the 10 K input and it works very well.     Since you are using resistors there is no freq. roll off.  A 600 to 10K transformer would also do but they are expensive these days for anything that is quality....   73  John VE3AMZ ----- Original Message ----- From: Kevin & Natalia To: Repeaters Users Group ; Repeater Builder Users Group Sent: Sunday, December 12, 2004 6:14 PM Subject: [Repeater-Builder] 600 - 10k ohm Interface Hi All,   I need a simple interface for a 600 ohm output radio to a controller which accepts 10k ohm. This is a RX not TX.   I don't want to make a circuit board if I don't need to.   Any ideas?   Regards   Kevin.   Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.