Merry Christmas Ralph and the List, Sounds more like a repeater trouble than a subscriber unit trouble. The 200 Hz. Tone level is probably a little too light. Most mfg specs call for +/- 750 hz CG deviation and between 500 and 750 seems to work pretty well. Less tone will probably chop with full modulation.
I would make sure the repeater receiver was properly aligned and make sure the IF was centered. Distortion or compression might make the tones difficult to decode. Power supplies and working voltages are a must. Keep up posted, Santa, Steve NU5D -----Original Message----- From: Ralph Hogan [mailto:[EMAIL PROTECTED] Sent: Friday, December 24, 2004 10:22 PM To: [email protected] Subject: RE: [Repeater-Builder] Help: GE M2 PL decode dropout on voice peaks and IDA control shelf Thanks guys for all the comments. Yes, the one ht I normally use on the bench may be a little hot on PL (er I mean CG hihi) Dev and voice dev, but not way out of bounds. Kind of one of [Steve Bosshard (NU5D)] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
