Look at your baud rate, make sure it is set to the correct speed. If the
RLX gets garbaged up, that is all you will get, and you will have to do a
master reset on the RLC contoller to get it to work again. A common problem
on the RLC controllers.
Mathew
I tryed a few things usggested on the GM300 set up this morning,
(jumper placement, etc.) now when I fire up Procomm, all I can
recieve from the RLC-4 is a bunch of ASCII charictures!!! I must
have changed some setting in Procom? i get ASCII chaictures for 137
(�), 162(�), 085 (U), 083 (S),115 (s), and 162 )�), instead of the
DTMF> prompt, any suggestions? I have tryed resetting the controller
and Procomm.
Bill
Yahoo! Groups Links
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
