Richard wrote:
> I'm not sure why it would take you "hours" to load and download the info -
> what do you mean by that? I program several RLC4s and an RLC3 and yes, there
> is a learning curve, but if you sit down for an hour or so with the manual
> it isn't really all that bad.
>
> The files I use to program the controllers contain anywhere from 10-30
> macros, plus all the timers, IDs, command prefix, and the other stuff I put
> in it, and it only takes three or four minutes to transfer it to the
> controller.
Pulling the programming out of the RLC-3 using the RS-232 port takes
several hours because of the slow baud rate used.
Only 10-30 macros? One guy printed out the programming he downloaded
from our clubs RLC-3-it made a stack of paper 2-3 inches thick!
--
Jim Barbour
WD8CHL
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
