Those should be good for 350 watts, 90-100 dB isolation per channel, 1.5-2.2 dB loss per side. Nice cans. The small tuning rod is the fine tuning adjustment for the bandpass, I believe.
Chuck WB2EDV ----- Original Message ----- From: "Mathew Quaife" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Tuesday, December 28, 2004 9:33 PM Subject: Re: [Repeater-Builder] TX RX Duplexer > > There is still plenty of tuning rod left, I would say it should go, but > hard > to tell much more about it than that. I looked on the website, but pics > of > them to go by. These can's are about 6.5" in Diameter and about a foot > high, with two tuning knobs on the top of them. > > Mathew > > >> >> At 12/28/2004 06:00 PM, you wrote: >> >> >> >Anyone have any idea how to identify a set of TX-RX duplexers for >> >the 450 band if there is no tags on it. The setting of the freq >> >that was written on them is 456.150. Any help would help. >> > >> >Thanks. >> > >> >Mathew >> >> If that freq. was stamped by the factory, it should tune down to 440 MHz >> with no mods or cable changes. >> >> Bob NO6B >> >> >> >> >> >> >> >> Yahoo! Groups Links >> >> >> >> >> >> >> > > > > > > > Yahoo! Groups Links > > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/

