At 1/9/2005 10:24 PM, you wrote:

>Mathew,
>
>When considering RF preamp gain, more is not always better.  I'm not
>familiar with the ARR preamp, but if it is a GaAsFET amplifier with 17
>dB or so of gain, and your bandpass cavities have 1.5 dB of insertion
>loss, I would put either a 6 dB or a 10 dB coaxial attenuator on the
>output of the preamp.  A net gain of 6 to 10 dB is usually enough to
>improve sensitivity without overloading the existing RF amplifier or
>mixer stages.

If you're using a G.E. Mastr (which one?) RX without a preamp, the ARR 
preamp is not going to overload the G.E.'s front-end.  Adding a 10 dB pad 
to the pramp output would knock your total gain ahead of the G.E. RX down 
to 5.5 dB.  OTOH if we're talking VHF you shouldn't need much gain ahead of 
the G.E. RX.  If we were talking UHF I'd say leave the pad out.

You didn't mention which G.E. RX you're using (MASTR Pro, II, 
Exec??)?  Anything other than a Mastr II will be a bit wide for 15 kHz 
spacing.  I know in the end the 9 kHz deviated signal is the culprit, but 
if you weren't getting adjacent-channel interference before it wouldn't 
take much of an improvement in IF selectivity to lose the interference 
while keeping the improved RX coverage.

Bob NO6B






 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to