Mathew,

It's definitely not normal.  Assuming that the person reporting the
problem has the equipment and expertise to accurately determine that
your repeater is transmitting a spurious signal, there are three
possibilities that come to mind:

1.  Your repeater is overdeviating due to a failure of the deviation
limiter.
2.  The exciter or driver stages are mixing with an earlier stage,
resulting in spurious emissions.
3.  The Diamond dual-band antenna may be enabling spurious responses
from your PA

Case in point:  A petroleum company operated a SCADA system whose base
station was 75 kHz below the output of one of my repeaters.  One day, I
began hearing the familiar sound of a 1200 baud SCADA signal right on my
repeater's output frequency.  When I set up a spectrum analyzer at a
hilltop site miles away from either the SCADA transmitter or my
repeater, I could see that a spurious signal almost exactly 75 kHz above
the fundamental always appeared each time the SCADA transmitter keyed
up.  I used a Doppler DF unit to track down the spurious signal right to
the SCADA tower.  It turns out that the SCADA system used a Motorola
M100 transceiver, and it had been the victim of a "diddle-stick artist"
who tried to get maximum power out of this low-tier radio.  Replacing
the radio with a much more robust unit cured the problem.

I am not familiar with Maggiore equipment, but I suspect that it does
not have all of the safeguards against spurious emissions that
commercial equipment has.  I would suggest exchanging the Diamond
antenna for one that performs well in duplex service.  But, before
blaming the equipment, it is important to determine- with the
appropriate test equipment- just what the problem is, and how it
occurs.  Moreover, hearsay does not rank high on the credibility
scale...

73, Eric Lemmon WB6FLY

w9mwq wrote:
> 
I had something brought to my attention yesterday on my 2 meter
repeater.  About 15 miles away, I'm being told that my repeater can
be heard on the output for about 20 to 25 kHz away.  From what I am
told, it is not intelligible, but it's there.  The transmitter is a
Maggiore Hi-Pro running about 2.5 watts and the PA is a Vocom 200
Watts.  I'm getting right about 165 watts out of the duplexer, fed
through 7/8" hardline 160' to the top of the tower into a Diamond Dual
Band Antenna with a VSWR of 1.1 with 1/10 of watt reflected.  Is this
normal, or is there a problem?





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to