That's easy....just wind up about 25-30 feet of RG-174 coax and install
that between the 2 watt exciter and the Vocom Amp. That wound up coax
will give you about a 3 Db loss at 146 mhz and supply only 1 watt to the
amp instead of the 2 watts.  Very simple and highly
reliable.......nothing to break.

Ron Rogers 
WW8RR

-----Original Message-----
From: w9mwq [mailto:[EMAIL PROTECTED] 
Sent: Tuesday, January 18, 2005 12:53 PM
To: [email protected]
Subject: [Repeater-Builder] Re: Adjacent Channel Noise, how far should
it be heard



I want to say thanks to all those that replied on this matter, I 
believe I have it fixed.  Found that the deviation had changed and 
was running at about 6 Khz wide.  Not sure why, unless a pot had a 
dirty spot on it.  Everything looked ok on the spectrum analyzer.  
Someone asked why I was running so much power.  Not that I am a 
power hog, but I took off the Motorola PA that everyone said would 
go bad, and replaced it with a Vocom 200 watt amp, just have not 
built a pad large enough to drop the power output.  2 watts drives 
the PA at 200 watts.  All that will have to change when the antenna 
goes up at 150 feet.  Again, want to say thanks for the quick 
responses.

Mathew


And yes the Diamond Antenna is only a temp setup, as it will be 
replaced with a DB224 when the new tower goes up.









 
Yahoo! Groups Links



 









 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to