As others have said, the model# is key to knowing what to expect. My personal experience is that if you are in the 146 or 147 MHz range you may be OK, but if you are in the 145MHz range, you will probably need to convert your amp to the low range. My TLD-1693 amp would only make about 20 watts and had higher than normal current draw when attempting to run it at 145.230. The TLD-1692 amps are out there, but are somewhat hard to find. Good luck and 73,
Kevin, K9HX
At 10:38 AM 1/20/2005, you wrote:
I have a 110 watt PA from a micor base, that was on the low end of the 150mhz range. Am I correct in assuming this should tune up fine on the 2 meter band? Also, I believe these require about 400mw drive but I want to confirm it. I think I have the schematics for this someplace but have to dig them up if needed. TIA to all.
Kevin
K2KMB
Yahoo! Groups Links
- To visit your group on the web, go to:
- http://groups.yahoo.com/group/Repeater-Builder/
- To unsubscribe from this group, send an email to:
- [EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
