Ok, I know this sounds silly, but my repeater is now hearing better 
than it transmits.  Here's the setup, the the issue.  I have a 
Maggorie (no comments) HiPro transmiitter running 2 watts into a 
Vocom Amp running 160 Watts into the duplexer, 130 out to the 
antenna, fed with 7/8" hardline into a Diamond Dual Band Antenna at 
92'.  VSWR is 1.1:1, with 130 watts forward and 1/10 watt reflected 
at an impedance of 52 ohms, (MJF 259).  

The receiver is a GE Mastr Pro ER-41 series receiver, tied to an ARR 
preamp at 24 db going through a two of the DB 4001-1 for filtering 
and finally into a set of TX-RX Duplexers, 3 cans pers side.

I used to be able to hear the repeater nearly full scale for about 
40 miles with no problem.  Recently at 20 miles away, it's barely at 
1/4 scale on my radio.  This has been noticable with several users 
on the system, and my mobile just got a new antenna, all set and 
tested fine there, and other repeaters there is no problem.  I can 
hear users nearly 60 miles from the repeater, but they can't hear 
the system.  

Is it possible something could be wrong on the duplexer end of it.  
I get no decense on the system, and receive audio is ok quality at 
60 miles, just less than full quieting.

Any thoughts.  Mybe just propagation.

And the 160 watts from the Vocom amp was as low as I could go before 
I began to cause havick, so it does not like lower power.

Mathew     Thanks!








 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to