Hi,
I reread my original post, it should read the following:
I am looking to use a Sinclair Reslok Q3220E UHF duplexor (insertion loss
of .5 dB and rejection of 65 dB) tuned to 444.975/449.975 mhz. I have a UHF
Master 2 repeater (run 30 watts) and a spare UHF receiver. I plan to have
one receiver tuned to 449.975, the second to 449.950. I also have a high Q
bandpass filter. If I was to run after the duplexor the bandpass filter
tuned to 449.9625, (then a low gain preamp) then a tee then 1/4 wave of
feedline (take in account velocity factor) to each receiver would this work?
Is there a better way to do this?
The site is at a commercial broadcast site, antenna is at 300 feet (2 bay
folded dipole) and is replacing an exec 2 repeater at the same site, which
works quite well.
Any ideas or suggestions?
Derek - VE5SD
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
